Docking Headlights

FEATURES:

Mounting Instructions

Removable:

1. Clean surface under bow for placement of headlight.
2. Suction cups should be dampened with water, or for better results, with some type of cola.
3. Position headlights under bow and apply pressure until suction cups are fully depressed.
4. If more or less wire is needed between the two housings, pull bulb out of single wire housing by rolling back the rubber housing, and adjusting wire accordingly.
5. Run the 20 ft. power cord down the railing of boat and attach to battery.
6. Foot pedal placement - where the power cord passes the console, splice into one wire of the power cord, and attach foot pedal wires.

NOTE: Before placing boat in water, check all suction cups to be sure they are fully depressed. Afrer placing boat in water, to adjust beams, move rubber housing forward or backwards and/or swivel left or right according to direction.

Permanent:

1. Mark positions under bow for permanent placement of headlights.
2. Drill 1/2" hole, insert rubber grommet and tighten bolt.
3. Follow instructions 4 through 6 on removable headlights for the remaining procedure.

NOTE: To remove for daytime fishing, taking out rubber grommet and bolt from the light and bracket, and insert back in hole and tighten to protect hole from water.